Psion Teklogix netpad Manual do Utilizador Página 190

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 189
Chapter 8: netpad Accessories
4-Bay Battery Charger Installation
164
Psion Teklogix netpad Windows CE .NET 4.2 User Manual
If a battery is left in the charging station, the charger will periodically refresh the
battery's charge. To remove the battery, press down the latch on the top of the battery
and lift the battery from the charging station.
Important: It is recommended that if there is no power connected to the
battery charger, then all batteries should be removed.
Summary of Indicators:
8.4.3 4-Bay Battery Charger Installation
Connect the power lead to the power supply.
Connect the power supply cable to the power socket located at the back of
the charger.
Connect the power lead into a power outlet.
The center LED indicator on the front of the charger will light up (red) indicating
the charger is ready to use.
8.4.4 Portable Battery Charger Installation
AC Power Unit
Connect the power lead to the power supply.
Connect the power supply cable to the power socket located at the back of
the charger.
Connect the power lead into a power outlet.
DC Vehicle Power Unit
Connect the cigarette lighter plug into the vehicle cigarette lighter socket.
Connect the power supply cable to the power socket located at the back of
the charger.
The lower LED will light up RED, to indicate power. The top LED will cycle
through Green, Red, Yellow, to off, indicating that the charger is ready for use.
RED
The battery is charging.
Flashing RED
The battery is either too hot or too cold before attempting to charge or
during charging, or is not functioning properly so it cannot be charged.
GREEN
The battery is fully charged and ready.
Vista de página 189
1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 229 230

Comentários a estes Manuais

Sem comentários